HowTune

1965 Chevrolet Belair Recalls

  1. Recall Description

    EXHAUST EMISSIONS (CARBON MONOXIDE) MAY ENTER THE INTERIOR OF THE VEHICLE WHEN THE EXHAUST PIPE IS SUBSTANTIALLY OUT THE DESIGN POSITION, DETERIORATED FROM USE, OR WHEN AN OPENING IN THE BODY DEVELOPS NEAR THE EXHAUST OUTLET AND, AT THE SAME TIME, A NEGATIVE AIR PRESSURE OCCURS IN THE VEHICLE INTERIOR.

    Possible Effects

    UNDER THESE CONDITIONS, VEHICLE OCCUPANTS MAY EXPERIENCECARBON MONOXIDE POISONING.

    Action

    RESEAL NEARBY BODY JOINTS AND REPLACE THE DRAW PLUG IN THE BODY WHICH WAS USED TO REMOVE SURPLUS BONDERIZING SOLUTION DURING MANUFACTURE.

    Notes

    SYSTEM: EXHAUST.VEHICLE DESCRIPTION: PASSENGER CARS.

    Recall Manufacture Dates

    -

    Vehicles Affected

    2570914

  2. Recall Description

    THERE IS A POSSIBILITY THAT A SEPARATED MOTOR MOUNT MAY ALLOW THE ENGINE TO LIFT, WHICH MAY AFFECT THE THROTTLE LINKAGE, MOMENTARILY INCREASING THROTTLE, POSSIBLY TO FULL THROTTLE.

    Possible Effects

    UNEXPECTED LOSS OF THROTTLE CONTROL MAY CAUSE LOSS OFVEHICLE CONTROL AND AN ACCIDENT.

    Action

    INSPECT ENGINE MOUNTS AND INSTALL RESTRAINTS WHICH WILL LIMIT ENGINE LIFT AND ELIMINATE POSSIBLE SECONDARY EFFECTS TO THE THROTTLE LINKAGE DUE TO ENGINE MOUNT SEPARATION.

    Notes

    SYSTEM: ENGINE.VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT TRUCKS AND VANS.

    Recall Manufacture Dates

    -

    Vehicles Affected

    6682084

  3. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBILITY THAT, AFTER EXTENDED MILEAGE, THE IDLER ARM ASSEMBLY COULD SEPARATE DURING VEHICLE OPERATION AND RESULT IN A SEVERE PULL TO THE RIGHT AS BRAKES ARE APPLIED AT LOW TO MODERATE SPEED.(INSPECT AND RE- PLACE IDLER ARM ASSEMBLY AS REQUIRED.)

    Recall Manufacture Dates

    -

    Vehicles Affected

    1143000

All belair Recalls

Other Chevrolet Recalls