HowTune

1983 Ford F800 Recalls

  1. Recall Description

    TWO-INCH SPACERS SPECIFIED FOR INSTALLATION BETWEEN THE FRONT AXLES AND EACH FRONT SPRING ASSEMBLY WERE OMITTED DURING MANUFACTURE. UNDER CERTAIN TURNING AND BOUNCING CONDITIONS, A FRONT TIRE COULD CONTACT ADJACENT VEHICLE COMPONENTS, RESULTING IN A POSSIBLE SEPARATION OF THE DRAG LINK TO STEERING ARM BALLJOINT OR LOSS OF TIRE PRESSURE.

    Possible Effects

    Action

    FRONT AXLE SPACERS WILL BE INSTALLED WITHOUT CHARGE.

    Notes

    VEHICLE DESCRIPTION: HEAVY TRUCKS EQUIPPED WITH 9,500 OR 12,000 POUND FRONTAXLES AND SINGLE REAR AXLES.SYSTEM: SUSPENSION; FRONT AXLE SPACERS.CONSEQUENCES OF DEFECT: BOTH CONDITIONS CAN CAUSE A LOSS OF STEERING CONTROLWITH THE POTENTIAL FOR AN ACCIDENT.NOTE: FRONT WHEELS SHOULD BE INSPECTED FOR INDICATIONS OF DAMAGE FROMCONTACTING THE FENDERS OR STEERING LINKAGE. DO NOT DRIVE ON TIRES THAT HAVECUTS PENETRATING THE TIRE CARCASS.

    Recall Manufacture Dates

    1982-10-01 - 1983-05-01

    Vehicles Affected

    305

  2. Recall Description

    ON THE AFFECTED VEHICLES, THE WIRING ASSEMBLY TO THE FLOOR MOUNTED HEADLAMP DIMMER SWITCH MAY BE TOO TIGHT; SHOULD WIRES DISCONNECT, THE HEADLIGHTS WILL NOT OPERATE.

    Possible Effects

    Action

    THE DEALER WILL MODIFY THE DIMMER SWITCH WIRING WITH A WIRE EXTENSION ASSEMBLY AT NO CHARGE TO OWNER.

    Notes

    VEHICLE DESCRIPTION: MEDIUM TRUCKS, HEAVY TRUCKS AND BUS CHASSIS.SYSTEM: LIGHTING AND COMMUNICATIONS; HEADLAMP DIMMER SWITCH WIRING HARNESS.CONSEQUENCES OF DEFECT: DRIVER FOOT PRESSURE ON OR ABOVE THE DIMMER SWITCH MAYRESULT IN DISCONNECTION OF THE WIRES AND SUBSEQUENT LOSS OF HEADLAMPILLUMINATION. HEADLAMP FAILURE COULD CAUSE A VEHICLE CRASH.

    Recall Manufacture Dates

    1982-11-01 - 1982-11-01

    Vehicles Affected

    300

All f800 Recalls

Other Ford Recalls