1990 Jeep Cherokee Recalls

1. Recall Description

   VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.

   Possible Effects

   THE REDUCED STRENGTH CAN ALLOW THE CAST IRON WEAR SURFACE TO SEPARATE FROM THE HUB, REDUCING THE BRAKE EFFECTIVENESS OF THE VEHICLE.

   Action

   DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.

   Notes

   OWNER NOTIFICATION BEGAN MARCH 9, 1998.OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHRYSLER AT 1-800-992-1997.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).

   Recall Manufacture Dates

   1989-07-01 - 1991-07-31

   Vehicles Affected

   293369

2. Recall Description

   VEHICLE DESCRIPTION: MULTIPURPOSE PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. DRIVERS CAN MISTAKENLY STEP ON THE ACCELERATOR PEDAL WHEN THEY INTEND TO STEP ON THE BRAKE PEDAL.

   Possible Effects

   PEDAL MISAPPLICATION BY A DRIVER CAN CAUSE UNINTENDED ACCELERATION.

   Action

   DEALERS WILL INSTALL A SHIFT INTERLOCK ON THE AUTOMATIC TRANSMISSION OF THESE VEHICLES.

   Notes

   NOTE:CHRYSLER HAS DECIDED TO CONDUCT A SAFETY IMPROVEMENT CAMPAIGN TO INSTALL A SHIFT INTERLOCK ON THESE VEHICLES.OWNERS CAN CONTACT CHRYSLER AT 1-800-853-1403.

   Recall Manufacture Dates

   1983-08-01 - 1995-07-31

   Vehicles Affected

   1010400

3. Recall Description

   VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH ANTILOCK BRAKE SYSTEM (ABS). THE ANTILOCK BRAKE SYSTEM (ABS) HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR WHICH COULD CAUSE PUMP-MOTOR DETERIORATION.

   Possible Effects

   IF THIS OCCURS, THE ABS FUNCTION WOULD BE LOSE AND REDUCED POWER ASSIST WOULD BE EXPERIENCED DURING VEHICLE BRAKING. THE INSTRUMENT PANEL WARNING LIGHTS WILL SIGNAL SYSTEM IMPAIRMENT AND THE BASE MANUAL BRAKES WILL REMAIN FUNCTIONAL.

   Action

   DEALERS WILL TEST THE VEHICLE''S ABS AND REPAIR AS NECESSARY. THE WARRANTY ON ALL ABS COMPONENTS WILL BE EXTENDED TO 10 YEARS OR 100,000 MILES (EXCEPT FOR THE BRAKE ACTUATOR PISTON ASSEMBLY AND THE PUMP-MOTOR ASSEMBLY WHICH WILL HAVE A LIFETIME COVERAGE). OWNERS WILL BE REIMBURSED FOR PREVIOUS ABS COMPONENT REPAIR COSTS.

   Notes

   OWNER NOTIFICATION BEGAN APRIL 24, 1997. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHRYSLER AT 1-800-853-1403.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S AUTO SAFETY HOTLINE AT 1-800-424-9393.

   Recall Manufacture Dates

   1988-07-01 - 1991-06-30

   Vehicles Affected

   52000

4. Recall Description

   IMPROPER INSERTION/CRIMPING OF THE HOSE-TO-END FITTINGS OF THE HIGH PRESSURE HOSE ON THE ANTI-LOCK BRAKE SYSTEM CAN CAUSE DETACHMENT OF THE HOSE FROM THE ABS SYSTEM, AND DISCHARGE OF HYDRAULIC FLUID.

   Possible Effects

   DETACHMENT OF THE HOSE FROM THE ABS SYSTEM CAUSES THELOSS OF THE ABS FUNCTION AND HYDRAULIC BRAKE ASSIST, LEAVING ONLY MANUAL BRAKESAND DECREASING STOPPING ABILITY, WHICH COULD RESULT IN AN ACCIDENT. DISCHARGE OFHYDRAULIC FLUID IN THE AREA OF THE HOT EXHAUST SYSTEM COULD RESULT IN AN ENGINECOMPARTMENT FIRE.

   Action

   REPLACE THE ABS HIGH PRESSURE HOSE.

   Notes

   SYSTEM: ANTI-LOCK BRAKE SYSTEM; ABS HIGH PRESSURE HOSE ATTACHMENT TO END UNIT.VEHICLE DESCRIPTION: MULTIPURPOSE PASSENGER VEHICLE.

   Recall Manufacture Dates

   1990-03-01 - 1991-03-01

   Vehicles Affected

   17000

5. Recall Description

   THERE MAY BE HYDRAULIC FLUID CONTAMINATION FROM CONDENSATION FORMATION THAT CAN PLUG THE ABS BRAKE BOOSTER PUMP FILTER; STRESS CORROSION OF THE MASTER CYLINDER SNAP RING HAS BEEN TRACED TO CHLORINE LEAKING FROM THE LOW PRESSURE HYDRAULIC HOSE WHICH MAY CAUSE IT TO BREAK; FRONT BRAKE HOSE TO TIRE INTERFERENCE WHICH MAY CAUSE FAILURE OF THE BRAKE HOSE.

   Possible Effects

   CONTAMINATION OF THE HYDRAULIC FLUID CAN CAUSEMALFUNCTIONING OF THE ANTI-LOCK BRAKE SYSTEM; LOW PRESSURE HOSE LEAKAGE CAUSESLOSS OF BRAKE FLUID AND ALSO RESULTS IN CORROSION AND FAILURE OF THE MASTERCYLINDER SNAP RING, RESULTING COMPLETE BRAKE FAILURE; FAILURE OF THE FRONT BRAKEHOSE DUE TO HOSE TO TIRE INTERFERENCE WILL CAUSE FAILURE OF ONE HALF OF THEBRAKE SYSTEM RESULTING IN A LONGER STOPPING DISTANCE THAN EXPECTED.

   Action

   REPLACE ABS LOW PRESSURE HOSE; REBUILD MASTER BRAKE CYLINDER; INSPECT, SERVICE INTERFERENCE PROBLEMS, AND REPLACE FRONT BRAKE HOSE AS NECESSARY.

   Notes

   SYSTEM: HYDRAULIC FLUID CONTAMINATION; ANTI-LOCK BRAKE SYSTEM (ABS).VEHICLE DESCRIPTION: MULTI-PURPOSE VEHICLES EQUIPPED WITH ANTI-LOCK BRAKESYSTEM.

   Recall Manufacture Dates

   1989-01-01 - 1990-06-01

   Vehicles Affected

   33000

6. Recall Description

   MALFUNCTION OF FUEL INJECTION SYSTEM THROTTLE POSTITION SENSOR COULD CAUSE INTERMITTENT HIGH ENGINE IDLE SPEED IMMEDIATELY AFTER STARTING ENGINE.

   Possible Effects

   HIGH ENGINE IDLE WHEN CAR IS FIRST PLACED IN GEAR COULDRESULT IN UNEXPECTED ACCELERATION.

   Action

   REPLACE THROTTLE POSITION SENSORS WITH SENSORS THAT WOULD SEND CORRECT SIGNALS TO THE FUEL INJECTION SYSTEM.

   Notes

   SYSTEM: THROTTLE POSITION SENSOR.VEHICLE DESCRIPTION: MULTI-PURPOSE VEHICLES EQUIPPED WITH 4.0 L ENGINE ANDAUTOMATIC TRANSMISSION.

   Recall Manufacture Dates

   1989-05-01 - 1990-06-01

   Vehicles Affected

   165000

7. Recall Description

   CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

   Possible Effects

   WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

   Action

   PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

   Notes

   THIS RECALL ONLY PERTAINS TO PRO-A MOTORS AFTERMARKET LAMPS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON THE LISTED PASSENGER VEHICLES.FOR MORE INFORMATION ON THE LAMP MODEL NUMBERS, CLICK ON DOCUMENT SEARCH AND VIEW DOCUMENT TITLED "LAMP MODEL NUMBERS."CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

   Recall Manufacture Dates

   -

   Vehicles Affected

   61944

8. Recall Description

   SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

   Possible Effects

   DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

   Action

   SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

   Notes

   THIS RECALL ONLY PERTAINS TO AFTERMARKET REPLACEMENT EQUIPMENT AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON VEHICLES PRODUCED BY THE VEHICLE MANUFACTURER.IN ORDER TO DETERMINE IF YOUR AFTERMARKET LAMP ASSEMBLY IS AFFECTED BY THIS NONCOMPLIANCE, PLEASE REVIEW THE LIST OF MODEL NUMBERS PROVIDED TO US BY SABERSPORT.THE LIST CAN BE FOUND UNDER "DOCUMENT SEARCH" LOCATED AT THE BOTTOM OF YOUR SCREEN.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO <A HREF=HTTP://WWW.SAFERCAR.GOV>HTTP://WWW.SAFERCAR.GOV</A> .

   Recall Manufacture Dates

   -

   Vehicles Affected

   16270

9. Recall Description

   DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

   Possible Effects

   DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

   Action

   DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.

   Notes

   THIS RECALL ONLY PERTAINS TO AFTERMARKET REPLACEMENT EQUIPMENT AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON VEHICLES PRODUCED BY THE VEHICLE MANUFACTURER.IN ORDER TO DETERMINE IF YOUR AFTERMARKET LAMP ASSEMBLY IS AFFECTED BY THIS NONCOMPLIANCE, PLEASE REVIEW THE LIST OF MODEL NUMBERS PROVIDED TO US BY DOPE, INC.THE LIST CAN BE FOUND UNDER "DOCUMENT SEARCH" LOCATED AT THE BOTTOM OF YOUR SCREEN. OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO <A HREF=HTTP://WWW.SAFERCAR.GOV>HTTP://WWW.SAFERCAR.GOV</A> .

   Recall Manufacture Dates

   -

   Vehicles Affected

   42540