HowTune

1992 Pontiac Grand Am Recalls

  1. Recall Description

    THE BOLTS AND NUTS WHICH ATTACH THE BEARING-HUB ASSEMBLY TO THE REAR AXLE FLANGE ARE NOT SUFFICIENTLY TIGHTENED ON SOME VEHICLES.

    Possible Effects

    THIS WOULD ALLOW EXCESSIVE MOVEMENT OF THE BEARING-HUBASSEMBLY RELATIVE TO THE REAR AXLE FLANGE AND COULD CAUSE ELONGATION ANDEVENTUAL SEPARATION OF THE ATTACHING BOLTS FROM THE REAR AXLE FLANGE. IF THISWERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, THE AFFECTED TIRE AND WHEEL COULDTRACK ERRATICALLY, EVENTUALLY CAUSING FAILURE OF THE OTHER ATTACHING BOLTS. THETIRE AND WHEEL ASSEMBLY COULD SEPARATE FROM THE VEHICLE WHICH COULD RESULT IN AVEHICLE ACCIDENT.

    Action

    TIGHTEN REAR AXLE BEARING-HUB ASSEMBLY FASTENERS, AND REPLACE ALL THE FASTENERS ON A WHEEL IF TWO OR MORE BOLTS ARE FOUND TO BE LOOSE.

    Notes

    SYSTEM: REAR AXLE.VEHICLE DESCRIPTION: PASSENGER CARS.NOTE: GENERAL MOTORS REPORTS THAT ALL SUBJECT VEHICLES WERE HELD AND REPAIREDBEFORE ANY OWNER TOOK POSSESSION, SO THERE WILL BE NO OWNER NOTIFICATION.

    Recall Manufacture Dates

    1991-07-01 - 1991-07-01

    Vehicles Affected

    272
  2. Recall Description

    THE VEHICLES WERE ASSEMBLED WITH AN INCORRECT SUSPENSION UPPER SPRING SEAT AT THE RIGHT-REAR POSITION. IF THE VEHICLE IS INVOLVED IN A REAR IMPACT ACCIDENT, THE RIGHT-HAND REAR WHEEL HOUSE FLANGE COULD SEVER THE FUEL TANK FILLER PIPE AND SPILL FUEL.

    Possible Effects

    THESE VEHICLES ARE NOT IN COMPLIANCE WITH FMVSS 301,FUEL SYSTEM INTEGRITY. SPILLED FUEL IN A LOW SPEED ACCIDENT CAN RESULT IN AFIRE.

    Action

    INSPECT AND REPLACE INCORRECT UPPER SPRING SEAT WITH THE CORRECT PART.

    Notes

    SYSTEM: FUEL SYSTEM: FMVSS 301.VEHICLE DESCRIPTION: PASSENGER CARS.

    Recall Manufacture Dates

    1992-06-01 - 1992-06-01

    Vehicles Affected

    20
  3. Recall Description

    THE PASSENGER''S SIDE EASY-ENTRY SEAT ADJUSTER MAY FAIL FULLY LOCK INTO POSITION AFTER THE SEAT BACK HAS BEEN TILTED FORWARD AND THE SEAT SLID FORWARD, THEN RETURNED TO ITS ORIGINAL POSTITION.

    Possible Effects

    IF THE SEAT ADJUSTER FAILS TO LOCK INTO POSITION, THEPASSENGER SEAT WOULD SLIDE FORWARD IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.OCCUPANTS OF THE PASSENGER SEAT WOULD FACE INCREASED RISK OF SERIOUS INJURY.

    Action

    REPLACE THE ADJUSTER ASSEMBLY ON THE SEAT.

    Notes

    SYSTEM: INTERIOR SYSTEMS: SEAT BACK.VEHICLE DESCRIPTION: PASSENGER CARS; N COUPE MODELS.NOTE: GENERAL MOTORS HAS INFORMED THIS AGENCY THAT ALL REPAIRS WILL BE MADEBEFORE THE VEHICLE IS OFFERED FOR SALE.

    Recall Manufacture Dates

    1991-03-01 - 1991-09-01

    Vehicles Affected

    1851