HowTune

1991 Ford Escort Recalls

  1. Recall Description

    THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.

    Possible Effects

    THIS CAN RESULT IN LOSS OF VEHICLE STEERING CONTROL ANDAN ACCIDENT.

    Action

    DANA WILL PAY FOR REPLACEMENT AND LABOR COSTS OF THE ADJUSTMENT PIN WITHOUT CHARGE TO THE INSTALLING FACILITY AND THE VEHICLE OWNER. THESE PINS SHOULD BE REPLACED BY A FORD ORIGINAL EQUIPMENT PIN ASSEMBLY. OWNER OR INSTALLER INQUIRIES CONCERNING THIS RECALL CAMPAIGN SHOULD CONTACT DANA SERVICE CENTER AT 1-800-248-9606.

    Notes

    SYSTEM: SUSPENSION; INDEPENDENT FRONT.EQUIPMENT DESCRIPTION: OFFSET REAR TOE ADJUSTING PIN.NOTE: IF YOU HAVE ANY PROBLEMS WITH THE PIN REPLACEMENT REIMBURSEMENT PROGRAM,PLEASE CONTACT DANA SERVICE CENTER AT 1-800-248-9606. ALSO, CONTACT THENATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S AUTO SAFETY HOTLINE AT1-800-424-9393.

    Recall Manufacture Dates

    1992-12-01 - 1994-05-01

    Vehicles Affected

    919
  2. Recall Description

    THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.

    Possible Effects

    THE IGNITION LOCK CYLINDER MAY DISENGAGE FROM THESTEERING COLUMN HOUSING WHICH COULD CAUSE THE STEERING COLUMN TO LOCK UP,RESULTING IN LOSS OF VEHICLE CONTROL AND A POSSIBLE ACCIDENT.

    Action

    IF ONE OR BOTH OF THE ROLL PINS ARE MISSING OR NOT FULLY INSERTED, THE IGNITION LOCK HOUSING WILL BE REPLACED, ALONG WITH THE DOOR-LOCKS AND THE LIFTGATE OR DECK-LID LOCKS SO THAT KEY COMPATIBILITY IS MAINTAINED. IF BOTH PINS ARE PRESENT AND FULLY INSERTED, A PLASTIC SNAP-ON SLEEVE WILL BE INSTALLED AS A PRECAUTION TO PREVENT THE ROLL PINS FROM COMING OUT.

    Notes

    SYSTEM: STEERING.VEHICLE DESCRIPTION: PASSENGER CARS.

    Recall Manufacture Dates

    1990-07-01 - 1991-05-01

    Vehicles Affected

    91000
  3. Recall Description

    FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.

    Possible Effects

    SHOULD A CRACK DEVELOP, FUEL VAPOR CAN ESCAPE FROM THETANK WHEN THE TANK IS FULL, AND A SMALL AMOUNT OF FUEL CAN LEAK FROM THE CRACK.FUEL LEAKS CAN RESULT IN FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.

    Action

    INSTALL A NEW FUEL PUMP SENDING ASSEMBLY.

    Notes

    SYSTEM: FUEL SYSTEM.VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH FUEL PUMP SENDINGASSEMBLIES PRODUCED BY FORD ELECTRICAL AND FUEL HANDLING DIVISION (FEHD).

    Recall Manufacture Dates

    1991-04-22 - 1991-08-30

    Vehicles Affected

    22000
  4. Recall Description

    INTERFERENCE OCCUR BETWEEN BOLT THAT SECURES A FUEL LINE SHIELD TO THE LOWER PORTION OF THE DASH PANEL AND THE ACCELERATOR PEDAL.

    Possible Effects

    THIS COULD CAUSE THE ACCELERATOR PEDAL TO STICK AT THE WIDE OPEN THROTTLE POSITION AND RESULT IN LOSS OF CONTROL WITH THE RISK OF A VEHICLE ACCIDENT.

    Action

    CUT OFF EXTRA LENGTH OF BOLT THAT PROTRUDES ABOVE SURFACE OF WELD NUT TO PREVENT INTERFERENCE.

    Notes

    SYSTEM: THROTTLE LINKAGES. VEHICLE DESCRIPTION: PASSENGER CARS.

    Recall Manufacture Dates

    1990-02-01 - 1990-04-01

    Vehicles Affected

    6000

All escort Recalls

Other Ford Recalls